smoothhwa.blogg.se - How to find local ip address on mac

Click the PDU and note the following information from the Outbound PDU Layer tab: Switch to simulation mode and repeat the ping 10.10.10.2 command. Step 1: Gather PDU information as a packet travels from 172.16.31.5 to 10.10.10.2.Ĭ. Pay close attention to the MAC addresses used. Study the process that takes place to communicate with devices on the remote network. In order to communicate with remote networks, a gateway device is necessary. Part 2: Gather PDU Information for Remote Network Communication Repeat the process in Step 1 and gather the information for the following tests: Record the PDU information you gathered into a spreadsheet using a format like the table shown below:Įxample Spreadsheet Format At Device Dest. Repeat this process until the PDU reaches its destination. Gather the same information from Step 1d.

Click Capture / Forward (the right arrow followed by a vertical bar) to move the PDU to the next device.

Destination MAC Address: 000C:85CC:1DA7Į.

Click the PDU and note the following information from the OSI Model and Outbound PDU Layer tabs: Switch to simulation mode and repeat the ping 172.16.31.2 command. Click 172.16.31.5 and open the Command Prompt.Ĭ. It will give you an idea of the type of information you will need to gather. Note: Review the Reflection Questions in Part 3 before proceeding with Part 1. Instructions Part 1: Gather PDU Information for Local Network Communication You will gather PDU information in simulation mode and answer a series of questions about the data you collect. This activity is optimized for viewing PDUs. Part 2: Gather PDU Information for Remote Network Communication Background Part 1: Gather PDU Information for Local Network Communication

9.1.3 Packet Tracer – Identify MAC and IP Addresses – ILM Objectives